Guide
Getting Started
From sealed box to your first scan in under 15 minutes.
On this page
What's in the box
- Cute Markhor device — the pocket WiFi hacking tool
- Charging cable — top up before first use
- Quick-start card — the 5-minute tour of the interface
Setup steps
1
Charge fully
Plug in the included cable and charge to 100% before the first power-on. A full charge gives you the longest first session.
2
Power on
Switch the device on and wait for the main menu to load — about 10 seconds.
3
Tour the menu
Follow the quick-start card: each tool is one tap away. Nothing to install, no app needed, no account required.
4
Check for updates
Open the update option in the menu — if a new firmware is available, install it with one tap. See firmware updates.
5
Run your first scan
Open the scanner and watch your neighborhood's networks appear. Start by exploring — every network you see is a lesson.
Your first scan — do it right
Scanning is passive and safe: you're only listening. But the moment you move to active tools (deauth, evil twin, jamming), one rule applies:
Only test networks you own — your home router, your lab setup — or networks where you have explicit written permission. Everything else is off-limits, and against the law (PECA 2016). Our full Ethical & Legal Use policy explains why.
Pro tips
- Start with your own router: change its password to something weak, then audit it — you'll learn more in 20 minutes than in hours of videos.
- Keep it charged: active scanning uses more power; top up between sessions.
- Join the community: the WhatsApp channel posts tips and firmware news.
- Stuck? The Support Center covers common issues, and WhatsApp support is 24/7.